|Supply Voltage and Current||24V ac/dc ±20%
Power Consumption:approx. 3 VA / 3 W
|Supply Protection Circuitry||Protected against transient voltages and reverse polarity
|Output Configuration||Each normally-open output channel is a series connection of contacts from two forced-guided (mechanically linked) relays, K1-K2.
Contacts:AgNi, 5 µm gold plated
Low current rating:
Caution:The 5 µm gold-plated contacts allow the switching of low current/low voltage. To preserve the gold plating on the contacts, do not exceed the following max. values at any time.
Min. voltage:1V ac/dc
Min. current:5 mA ac/dc
Max. current:300 mA
Min. power:5 mW (5 mVA)
Max. power:7 W (7 VA)
High current rating:If higher loads must be switched through one or more of the contacts, the minimum and maximum values of the contact(s) changes to the following.
Min. voltage:15V ac/dc
Max. voltage:250V ac/dc
Min. current:30 mA ac/dc
Max. current:6 A
Min power:5 W (5 VA)
Max. power:200 W (1,500 VA)
Mechanical life:50,000,000 operations
Electrical life:150,000 cycles typical, @ 200 W (1,500 VA) switched power, resistive load
Note:Transient suppression is recommended when switching inductive loads. Install suppressors across load. Never install suppressors across output contacts.
|Output Response Time||35 milliseconds
|Input Requirements||Input switch must have a normally-closed contact and a normally-open contact capable of switching 5 to 50 mA @ 15 to 30 V dc.
Reset switch must have one normally-open contact capable of switching 5 to 50 mA @ 15 to 30V dc.
Max. external resistance between terminals S11/S12, S11/S13, S21/S22 and S21/S23: 270 ohms each.
|Simultaneity Monitoring||2-channel operation:3 seconds
|Status Indicators||4 Green LED indicators:
Power:power is supplied to safety module
Channel 1:inputs satisfied (guard closed)
Channel 2:inputs satisfied (guard closed)
Output:K1 and K2 energized, safety outputs closed
1 Red LED indicator:fault
|Environmental Rating||Rated IEC IP40; NEMA 1, Terminals IP20
|Mounting||Mounts to standard 35 mm DIN-rail track. Safety module must be installed inside an enclosure rated NEMA 3 (IEC IP54), or better.
|Vibration Resistance||10 to 55 Hz @ 0.35 mm displacement per IEC 68-2-6
|Operating Conditions||Temperature:0° to +50° C
Relative humidity:90% @ +50° C (non-condensing)
|Safety Category||4 per ISO 13849-1 (EN 954-1) (depending on application)